Ampler Stellar 2020 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Sepeda Latihan Ampler Stellar 2020. Ampler Stellar 2020 18 halaman.

Halaman Cetak

Software restart

Torque sensor calibration

Factory calibration

V2.3 03.11.20

Electric system support

Ampler hardware (the battery, controller and sensors) are inserted

into the down tube. This keeps the bike clean, the weight down, and

the components safe from outside elements such as the rain and cold

temperature.

The hardware doesn't need any special maintenance. However, we

recommend to keep your bike Firmware up to date and calibrate your

bike sensors from time to time. This will help to keep your bike in a

good shape for longer time.

Software restart clears up your bikes memory and starts it fresh. It

helps to resolve any problems connected to the hardware, and any

communication problems between the bike and the mobile app.

To reset your bike

1. Hold down the power button for 10 seconds. This will reset and

turn off your bike.

2. Turn on the bike again from the power button.

Ampler bikes are pedelecs and they have sensors regulating the

motor, measuring the speed of pedalling and your own input power.

Therefore, the bike is easy to use and the motor power is controlled

according to your own pedaling force. This creates a safe and smooth

riding experience.

We recommend to calibrate your bike's torque sensor every 3–6

months, or in case the bike feels over- or underpowered. Torque

sensor calibration is done via the Ampler app:

1. Adjust the left crank forward, parallel to the ground.

2. Connect the Ampler app with your bike via Bluetooth

3. Open 'Vehicle' setting from the menu

4. Click on 'torque sensor calibration'

5. The LED blinks in

orange

6. The LED will turn

green

Re-adjusting the sensor signal helps to improve your bike's responsi-

veness and power to its original fi gures.

Every Ampler has a motor controller – the so-called brain of your bike

that connects all the elctronics and makes sure everything runs

smoothly. The motor controller is managed by Firmware (the software

that controls the hardware). To guarantee the best riding experience,

we recommend keeping your bike's Firmware up to date.

Factory calibration will adjust all your bike's sensors and align the

functionality of all electronic components. Use this calibration only if

any of the electronic components have been replaced or only if re-

commended by Ampler support.

CAUTION! During the factory calibration, the motor starts on its own

and thus the rear wheel will start spinning. It is necessary for you to

once the calibration is successful