Advanced MxPro4 Series Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Alarm Kebakaran Advanced MxPro4 Series. Advanced MxPro4 Series 12 halaman. Sounder booster
Juga untuk Advanced MxPro4 Series: Lembar Instalasi & Panduan Referensi Cepat (4 halaman), Manual (6 halaman)

Halaman Cetak

2 Commissioning

All commissioning items are accessed by using the navigation keys and selecting the appropriate item from the

commissioning menu. Wherever possible the menus have been chosen to follow a similar format to the MX fire

panels.

[Commission Menu 1]

PASSWORDS

EXIT

PC-CONFIG

VIEW

The steps needed to configure the remote terminal are as follows: -

a) Enter network and service details from SETUP

b) Use the PASSWORD option to enter any custom passwords.

c) Use the ZONE option to enter the text corresponding to the terminal's zone.

EXIT from commissioning into normal Level 2 operation. Check network.

2.1 Passwords

Allows the passwords used for level 2 and level 3 accesses to be changed. The remote terminal uses the same

defaults as the fire panel.

2.2 Zone

Shows the text corresponding to the terminal zone. Pressing the Tick key allows the text to be changed. It is

recommended that text be chosen that describes where the terminal is in the building, so that in the event of the

EVACUATION key being used, all panels and terminals on the network will show where the fire has been detected.

This text will also be displayed if the terminal's monitored power supply FLT input goes open or short circuit.

2.3 Exit

Once commissioning is completed, use Exit to return the terminal to normal level 2 operation. It is recommended

that once at level 2, the VIEW/NETWORK option be used to check the network configuration (see network

document for details).

2.4 Setup

Basic network configuration must always be performed first: -

[Setup]

THIS NETWORK NODE

NEXT NETWORK NODE

TERMINAL ZONE

SERVICE NUMBER

"THIS NETWORK NODE"

"NEXT NETWORK NODE"

"TERMINAL ZONE"

ZONE

SETUP

01234 567890

- The network node address for this terminal.

- The address of the next network node

- The zone number used to identify this terminal – select a number that is not being

used by the fire panels or other terminals.

- (The text description of the zone is entered from the "ZONE" option off the

commission menu)