Amplicomms TV3500 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Headphone Amplicomms TV3500. Amplicomms TV3500 15 halaman.

Troubleshooting

No sound

- Ensure that the mains adapter is fully pushed into the power outlet and that

its cable is properly connected to the DC IN connector on the base.

- Ensure that the headset ON. Either red or blue LED is steady on.

- The charge level of the headset battery may be too low. Put the headset on

the charging cradle for 2 hours.

- Ensure that the TV set, Hi-Fi system or audio device is switched ON and the

input source selection/connection is correct (AUX switch).

- The connected audio/video equipment may not be in playback mode. Start

playback on the equipment.

- The headset output level is set too low. Adjust the volume to a suitable level

with the remote control.

Distortion

- The headset may be too far away from the base. Move closer to it.

- The audio signal input level is too low/high. Increase/decrease the volume

from the audio source TV/Hifi.

Please read this operating instruction manual thoroughly.

Intended use

This device was developed to transmit audio signals from an audio source like

TV or HiFi device to a headset, using cordless transmission. Any other use is

considered unintended use. Unauthorised modification or reconstruction is not

permitted. Under no circumstances open the devices or complete any repair

work yourself.

Installation location and safety information

• Prevent excessive exposure to smoke, dust, vibration, chemicals, moisture,

heat and direct sunlight.