Advanced Mxp-537 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Sistem I/O Advanced Mxp-537. Advanced Mxp-537 12 halaman. Peripheral input card

3 Card Configuration Setup

Expand the Panel (in the "Site List") and select the "Peripheral Bus" node; this will bring up a list of available

cards that can be connected to the peripheral bus in the "Device Selector".

Select the 10 Way Input Monitor and add it to the design.

The device must be added to the same DIP Switch address as the one set on the card.

Input configuration is performed along the same line as configuring any other input device.

Setting the "Input Action" to "No Action" has the following impact:

Input is disabled at the hardware end (overall power consumption is reduced)

End of Line resistors are not required for unused inputs.

By default all inputs are set to Un-Monitored; "Input Monitored" should be checked for any input that needs to

detect Open circuit and Short circuit faults.