Amplink PDM60 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Unit Kontrol Amplink PDM60. Amplink PDM60 12 halaman.

Device Overview

Red 10 awg main +12V power wire

Connect directly to the positive pole of the vehicle battery. Always connect the + before

connecting ground. For additional protection, a high amperage fuse (not included) can be added

between the Amplink PDM and the battery. To extend the length we recommend using 8 awg

automotive crosslink wire.

Black 18 awg internal ground wire

Connect directly to the battery ground or suitable ground point like the ground bus cable included.

Connect the Amplink ground (black) wire after connecting the red + to the battery.

Triggers 20 awg input wires (white-T1, purple-T2, yellow-T3)

Connect 1, 2 or 3 triggers to achieve desired functionality. Trigger 1 (white) must be connected.

These wires are stamped "TRIGGER1", "TRIGGER2", "TRIGGER3"

Outputs 14 awg (white, purple, yellow, pink, green, orange)

Connect these output wires to the +12V input wire of the accessory to be powered. Each output is

stamped with "OUTPUT" and the corresponding circuit number.

Always Live 14 awg wire (red with white stripe)

The always live output, stamped "ALWAYS LIVE", allows low amperage battery charging

through the Amplink PDM. Please note: There is no monitoring or protection on this always

live circuit. It should be capped or taped off if not being used.

+ 12 V to battery

always live

ground to battery

output 6

output 5

output 4

trigger 3

output 3

trigger 2

output 2

trigger 1

output 1

Page 3 of 12