AmpliVox Mega Hailer S680 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembicara AmpliVox Mega Hailer S680. AmpliVox Mega Hailer S680 13 halaman. Battery powered pa system with bluetooth
Halaman Cetak
WIRELESS SPEAKER TRANSMITTER S1692T (OPTIONALEQUIPMENT)
OPERATES ON DIFFERENT FREQUENCIES THAN AMPLIVOX WIRELESS MICROPHONE / RECEIVER
16 CH UHF WIRELESS SPEAKER TRANSMITTER
FEATURES
•
Channel Display (A) Frequency: 655 - 679 MHz
•
TX - Radio Frequency Indicator (B) lights when turned on
•
AF - Audio Frequency Indicator (C) lights when transmitting
•
Select Buttons - Manual Channel Selection (D) Up / Down
•
Power / Volume Control (E)
SETUP
• The transmitter has its own POWER / VOLUME Control (E). First make sure that you have screwed on the UHF
antenna (Position #4). Turn Main Power On of the S680 / SW680 / SW685, then turn transmitter Power On (E). A
Frequency Channel will appear in the Channel Display (A). Press Select Buttons (D) to select a channel. Channel
number must match channel number on wireless receiver of the AIR Vox Speaker. EXAMPLE: Select Channel
10 on transmitter (S1692T) and select Channel 10 on the speaker receiver of the SW690. The AF LED will
light when transmitting signal to receiver of the SW690. RF LED of receiver (SW690) will light when channels are
matched and receiving a signal.
OPERATE
• S680 / SW680 / SW685: turn on main power / wireless microphone receiver / wireless speaker transmitter / wire-
less microphone.
• SW690: turn on main power / wireless speaker receiver.
• To start, set all volume controls of the wireless devices to MID POINT. Test speaking into the wireless microphone
and adjust level of main volume controls first to the desired level. If you feel that you need to increase sound level
then adjust levels of the wireless devices.
S680 / SW680 / SW685
Model SW680 Shown
With Wireless Speaker Transmitter
A
D
SW690
9
B
C
E