AmpliVox S1500 Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Podium AmpliVox S1500. AmpliVox S1500 4 halaman.

WIRELESS HANDHELD MICROPHONE—MODEL S1695

If you are using the AmpliVox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of mi-

crophone and insert 2 - "AA" 1.5 Volt alkaline batteries.

IMPORTANT: Because the microphone has an AUTO SYNC function, you first select channel you wish to use on the re-

ceiver. Then press the ASC button (D), the IR light will start to flash. Turn on microphone and point end (6) of microphone

at the flashing IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.

BATTERIES

1. Hold the body of microphone in hand and twist off

bottom section of microphone.

Insert two "AA" batteries.

3. Twist bottom section back on to microphone.

BATTERY STATUS

The life expectancy of the two batteries is about 10

hours. When the "BATTERY" symbol on the display

screen keeps flashing the batteries should be replaced

immediately.

Functions

1) Interchangeable Microphone Head

2) LCD Screen

3) Power / Mute Control Switch

4) Select Button

5) Microphone Input Sensitivity Ad-

justment—is used to set the gain of

microphone. If you are a soft talking

speaker you will need to turn the control

counter clockwise. Turn clockwise if you

are a loud talker. Use plastic screwdriver

that is supplied.

TURN ON MICROPHONE: Push and hold the

"POWER/MUTE" (3) button until LCD screen

lights up.

TO MUTE: Press "POWER/MUTE" button twice

to MUTE. Channel number will flash when muted.

Press button again twice to remove "MUTE".

TURN OFF MICROPHONE: Push and hold the

"POWER/MUTE" (3) button for 2 seconds to turn

microphone "OFF".

SELECT CHANNEL (Manual): Press and hold

the "SELECT" (4) button for 2 seconds until you

only see the word Channel and channel number.

To change channel, when flashing, press the

"SELECT" (4) button until you reach the desired

channel. Flashing will stop after 10 seconds and

channel is now set.

LOCK / UNLOCK CHANNEL: Push the

"POWER/MUTE" (3) button and "SELECT"

button at the same time to lock or unlock channel.

When locked, channel cannot be changed.

"LOCKED" symbol appears in upper left-hand

corner.