Comco AccuFlo AF10-E Panduan Peralatan - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Peralatan untuk Alat Listrik Comco AccuFlo AF10-E. Comco AccuFlo AF10-E 14 halaman. Micro-abrasive blaster

Halaman Cetak

Comco warrants that the AccuFlo® model AF10‐E will be free from all defects in material and workmanship

under normal use for a period of one year from the date of purchase or 2,000 hours of normal operation,

whichever comes first.

The warranty period begins when the equipment ships from the Comco facility and applies to the original

owner only. Comco is not liable for damages from any cause or use of such equipment beyond the cost of

repairing any defective parts.

If the equipment fails to perform satisfactorily during the warranty period, Comco has the option to do any

one of the following: 1) Send replacement parts to the customer to be installed by the customer; 2) Repair

the unit at the customer's facility; or 3) Request that the unit be returned to the Comco factory. Any

replacement parts shall be furnished by Comco without cost, F.O.B. the Comco factory in Burbank, California,

provided that Comco is notified of the defect within the warranty period. Any defective parts shall be

returned to Comco for inspection and analysis.

Exclusions

The above warranty does not apply to defects or problems resulting from improper or inadequate

maintenance by the customer; unauthorized modification or misuse; failure to follow the operating

instructions; the use of any supplies or parts, including but not limited to nozzles, powders, and attachments,

not manufactured or supplied by Comco.

The warranty also does not cover problems resulting from improper or inadequate facilities (contaminated

air; improper power) or items that should be expected to wear in normal operation, such as nozzles,

abrasives, tubing or fittings.

This is Comco's only warranty and is in lieu of all other warranties of merchantability and fitness for any

particular purpose. No representations or warranties are authorized except as herein stated.

Always operate the AccuFlo® blaster in an appropriate

workstation with dust collection.

Never blast toward someone's face or eyes. This is a

pressure device.

The Lexan window on the tank cover is abrasion

resistant. However, contact with certain chemicals can

weaken the cover and cause it to crack.

Inspect the cover daily and replace immediately if

cracks develop.

Refer to Comco Technical Support for full details.

The Comco Warranty

WARNING

MAXIMUM BLAST SETTING ON YOUR BLASTER

Never operate any micro‐abrasive blaster with

the air pressure regulator fully open. Check your

compressor settings to determine the air pressure

level it uses to trigger the re‐pressurize cycle. The

blast pressure setting on your blaster should

always be set at 10 psi below this point, which is

the lowest supply pressure coming from your

compressor. If the inlet pressure drops below the

blast pressure setting, air and abrasive will flow

backward through your system and damage

critical components.

Tech Support: 1‐818‐841‐5500