Ampro NEO 300 BEAM Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan DJ Ampro NEO 300 BEAM. Ampro NEO 300 BEAM 18 halaman. Moving head
Halaman Cetak2. SAFETY INSTRUCTIONS
For your own personal safety, please
read and understand this manual
completely before you attempt to
install or operate this unit!
DANGER!
Hazardous voltage.
Risk of lethal or severe electric shock.
WARNING!
Wear protective eyewear. Never look
directly into the light source.
•
When unpacking , check if there is transportation
damage before using the projector. Should there be any
damage caused by transportation, consult your dealer
and do not use it.
•
The manufacture is not responsible for loss caused
by the user not following the manual or changing the
projector as he/she likes.
•
Please be noted that the damage caused by changing
the projector at will is not warranted.
•
Do not hesitate to contact the dealer or the
manufacturer if any questions or advice.
•
If a lamp is damaged or deforms because of heat, it
should be replaced.
•
The projector is for indoor use only, IP20.
•
Use only in dry locations. Keep this unit away from rain
and moisture, excessive heat, humidity and dust. Do
not allow contact with water or any other liquids.
•
The projector should be kept away from high
temperature, fire, electrical surge, vibration and strong
light while being operated.
•
The projector is only intended for installation,
operation and maintenance by qualified personnel. And
the operation must strictly follow the procedures in the
manual.
•
No repairable parts in the projector and do not open
covers for maintenance by yourself.
•
Don't look straightly into the light sources especially for
epileptics, otherwise eyes will be burned.
•
Do not connect a projector to any type of dimmer pack.
•
If the lamp, lens and screen protective cover of the a
projector have obvious damage, i.e., to the extent that
WARNING!
Burn hazard. Hot surface.
Do not touch.
Only to direct mounting on non-
combustible surfaces.
it hurts the performance like cracking or deformation.
Please stop using it and replace them with the original
parts, otherwise its performance will be compromised.
•
For the installation location of a projector, it shouldn't
be seen in the distance of less than 4 meters for a long
time.
•
Before operation, please confirm that all
covers(housing) are on and screws tightened. It's
forbidden to use a projector while covers(housing)are
off.
•
Keep the lamp clean and do not touch it with bare
hands.
•
While operating it, wear protective items.
•
Any electrical connection must be carried out by a
qualified person.
•
Before installation, please confirm the voltage supplied
matches what is required for the projector.
•
Each projector must be properly earthed and installed
as per related electrical standards.
•
Do not use power cord with its insulator damaged and
connect the power cord with other cables.
•
If the projector is not used or under cleaning,, please
hold the plug and unplug it. Do not unplug it forcefully
or by pulling the power cable.
•
All power cords must conform to related safety and
regulations.
•
While being operated, the projector should not be
under rains or in humidity.
•
Do not switch on and off the projector constantly in
very short intervals, otherwise the light source's and
other electrical parts' life will be shortened.
P. 3
English Version | NEO 300 BEAM