Amprobe ACD-15 Pro Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Amprobe ACD-15 Pro. Amprobe ACD-15 Pro 20 halaman. Clamp-on multimeter series

To avoid electrical shock hazard, observe the proper safety precautions when

working with voltages above 60 VDC or 30 VAC rms. These voltage levels pose a

potential shock hazard to the user.

Inspect test leads, connectors, and probes for damaged insulation or exposed metal

before using the instrument. If any defects are found, replace them immediately.

Do not touch test lead tips or the circuit being tested while power is applied to

the circuit being measured. To avoid accidentally short circuit of bare (uninsulated)

hazardous live conductors or busbars, switch them off before insertion and removal

of the current clamp jaws. Contact with the conductor could result in electric shock.

Keep your hands/fingers behind the hand/finger barriers that indicate the limits of

safe access of the meter and the test leads during measurement.

Do not use the instrument in presence of explosive gas (material),

CAUTION

Disconnect the test leads from the test points before changing meter functions.

INTERNATIONAL ELECTRICAL SYMBOLS

�

Caution ! Refer to the explanation in this Manual

�

Caution ! Risk of electric shock

�

Earth (Ground)

�

Double Insulation or Reinforced insulation

�

AC--Alternating Current

�

DC--Direct Current

�

Fuse

Conformity symbol, the instrument complies with the valid directives.

�

It complies with the EMC Directive (89/336/EEC) and the Low Voltage

Directive (73/23/EEC) with their valid standards.

Symbol for the marking of electrical and electronic equipment (WEEE

�

Directive 2002/96/EC).

Application around and removal from hazardous live conductors is

�

permitted

combustible gas (material), steam or dust.