Amprobe ACD-21SWC Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Amprobe ACD-21SWC. Amprobe ACD-21SWC 17 halaman. Digital clamp meter

OPERATION

Data hold freezes the reading present on the LCD at the moment the button is

pressed.To use this menu feature, set up the meter for the type of measurement

and range desired.

Connect the test leads to the circuit / component to be measured and then press

"HOLD" push button. The LCD reading will freeze and display "HOLD." You may

now remove the test leads and the reading will not change until you press Hold

again.

This function allows the user to select the range of a function that does not show

'RANGE' on the LCD.

1. Set the Function Switch to L

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.1

4. Read the display. If necessary, correct any overload ( 0L) conditions.

1. Set the Function Switch to K.

2. Connect the test leads: Red to +, Black to COM.

3. Connect the test probes to the circuit test points. Refer to Fig.2

4. Read the voltage on the primary display and the frequency on the

secondary display. If necessary, correct any overload (0L) conditions.

1. Set the Function Switch to position ?.

2. Open spring-loaded clamp by pressing the jaw opening lever on the left

side of meter.

3. Position clamp around one wire or conductor. Release the jaw opening

lever. Wire should be center inside the jaws. Refer to Fig.3

4. Read the current on the primary display and the frequency on the

secondary display. If necessary, correct any overload (OL) conditions.