Follett H25R5A/W Panduan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Dispenser Follett H25R5A/W. Follett H25R5A/W 13 halaman. Ice and water dispenser
Juga untuk Follett H25R5A/W: Panduan Pengoperasian, Servis, dan Suku Cadang (17 halaman)

Halaman Cetak

Installing 25 and 50 Series wallhung dispensers

1. For all 25 and 50 Series wallhung dispensers, install supplied wall bracket

with six (6) 3/8" dia. fasteners as shown in diagrams below. (Note

that three holes are available at each fastening site to allow capture

of studs/support within wall.)

Steps 2 - 3 are required for Models H25T5A/W and H50T5A/W only.

2. For models with integral icemakers only (models H25T5A/W and

H50T5A/W), use straight edge to position filler strip flush with top

edge of wall bracket.

3. Fasten filler strip to wall as shown in drawings on page 7.

4. For all models, cut utility hole in wall using wall bracket as template.

5. Lift dispenser onto wall bracket, positioning unit such that hook on

back of dispenser is captured by wall bracket support angle.

Caution: Do NOT rest dispenser weight on

bottom front edge of wall bracket.

6. Install four (4) 1/4-20 screws through bottom of wall bracket into

bottom of dispenser to secure dispenser.

7. To gain access for final connections, remove access plate in bottom

of wall bracket.

Note: Electrical connection box can also be accessed through

front of dispenser by removing front cover, black plastic chute

cover and stainless splash panel.

8. If dispenser has remote icemaker and unit is equipped with water

station accessory, make water connection for water station inside

dispenser as indicated.

9. Proceed with instructions for installing remote or topmounted

icemaker as appropriate.

H25R5A/W mounting dimensions

support angle

9.5"

241 mm

Wall Bracket

9.5"

utility cutout

241 mm

3.40625" (87 mm)

11.4375"

4.59375"

125 mm

3/8"

Wall stud

fasteners (6 sites)

16"

406 mm

25.625"

651 mm

3.5"

89 mm

1.28125"

291 mm

33 mm

H25T5A/W

30.625"

77.8 cm

H50T5A/W

34.625"

88 cm

H25T5A/W

44.375"

112.71 cm

H50T5A/W

48.375"

122.9 cm

Side view and angle detail for wallhung units

with integral icemakers (in top of cabinet)

(Wallhung units with remote icemakers will not

require installation of a filler strip above support

angle and hook.)

H50R5A/W mounting dimensions

support angle

11.5"

292 mm

Wall Bracket

11.5"

utility cutout

292 mm

3.40625" (87 mm)

4.59375"

125 mm

ICDI220

Support angle and

hook detail

24.75

62.9 cm

17"

43.2 cm

19 3/8"

49.2 cm

Min. distance to

front of sink = 23"

(58.4 cm)

3/8"

Wall stud

fasteners (6 sites)

16"

406 mm

29.625"

752 mm

3.5"

89 mm

11.4375"

1.28125"

291 mm

33 mm

2.75"

7 cm

CL utility

entrance