Acer 7765PA - PalmPro XGA DLP Projector Panduan Pengoperasian - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Proyektor Acer 7765PA - PalmPro XGA DLP Projector. Acer 7765PA - PalmPro XGA DLP Projector 37 halaman. Digital multimedia projector
Juga untuk Acer 7765PA - PalmPro XGA DLP Projector: Panduan Pengoperasian (35 halaman)
Halaman Cetak
Operation
Turn On/Off Procedure
A
Power on
Press the Standby/On key to turn on the lamp. The LED will blink
green during warm up and then light solid green.
"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be
displayed on the screen after the projector has identified
the input signal;
"SEARCHING" message will be displayed on the screen if there
is no signal input;
"SYNC IS OUT OF RANGE" message will be displayed on the
screen
exceeds the range of the projector.
B
Standby
Press the Standby/On key for 2 seconds to turn off the lamp. The LED
will then blink orange and the lamp will shut down, but the fan will
continue to run for about 1 minute to cool the lamp. After the fan
stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again
while the LED is blinking, the projector will ignore the command
until it has cooled down for one minute.
if
the
horizontal
frequency
of
3
the
input
signal
English 9