DPCAV Oracle Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol DPCAV Oracle. DPCAV Oracle 11 halaman. Video diversity controller

SYSTEM PROGRAMMING INSTRUCTIONS

Oracle can be easily configured to your requirements. The system programming feature allows

you to set the following parameters:

Video Type (NTSC/PAL).

Switching Alert Chirp (On/Off).

Low Battery Alert Beep (On/Off).

Low Battery Alert Voltage (6.0V - 13.9V).

Switching Sensitivity.

Video Level Balance Adjustment.

Programming Oracle involves pressing the front pushbutton switch while observing the LED

indicators. The green V

steps, so there are six unique LED patterns that will be seen by the time programming is

complete. The programmed settings are stored and are not lost when power is removed.

At each step you will respond by pressing the push switch. The number of presses will program

the feature. For example, during the "Video Type" programming step, pressing the switch two

times will select the PAL video mode. Once you are done with the step, wait three seconds for

the yellow S

LED to wink once and it will move to the next step. If desired, programming

TATUS

can be exited by removing power after the yellow S

remaining values unchanged.

If a pushbutton response is not entered within seven seconds, Oracle's green V

report the existing stored setting by blinking out its code. The setting will not change and you

will move to the next step. Note: If your entry is illegal, all three LED's will rapidly flash for

several seconds as a warning. You will then be allowed to try again.

The LED patterns are arranged as simple patterns of short and long blinks. The following table

outlines the blink codes (

STEP

VID2 LED

1 LED's blink pattern indicates the programming step. There are six

= short blink,

DESCRIPTION

Video Type, 1=NTSC / 2=PAL

Switching Alert Chirp, 1=ON / 2=OFF

Low Battery Alert Beep, 1=ON / 2=OFF

Low Battery Alert Voltage, 6 - 13 VDC

Low Battery Alert Voltage, 0.0 - 0.9 VDC

Switching Sensitivity, 1=LOWEST, 5=HIGHEST

,, ,,

Video Level Balance Adjustment, 1=ON / 2=SKIP

LED winks, which will leave the

TATUS

= long blink).

AGE

2 LED will

Jan-2008