Carbon-Ti X-TORQUE CAP ADAPTER Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori Sepeda Carbon-Ti X-TORQUE CAP ADAPTER. Carbon-Ti X-TORQUE CAP ADAPTER 2 halaman.
Halaman Cetak
X-TORQUE CAP
ADAPTER
ENGLISH
Thank you for purchasing a Carbon-Ti product, any small aesthetic imper-
fection is due to the handmade manufacturing and contributes to exalt the
handcrafted nature.
FEATURES AND EQUIPMENT
The kit consists of two POM caps to apply to the axle's ends of the
front X-Hub SP or SL Boost hubs for facilitate the mounting on the
RockShox boost forks with 31 mm socket. No structural improve-
ments are proposed, but a faster and easier wheel change with a
little weight gain (less than 5 grams).
COMPATIBILITY
The X-Torque Cap Adapter is compatible only with the Carbon-Ti
X-Hub SP Boost or SL Boost front hubs.
The use on other hubs is not expected and may be dangerous.
1
INSTALLATION
The larger cap (n° 1) must be applied to the right side of the hub
where the bearing preload is present (see the image). The smal-
lest cap (n° 2) goes to the opposite side.
Apply the caps on both sides by using a plastic hammer making
sure that the hexagon of the hub's axle ends are fully inserted
into the caps.
Check periodically the correct fixing and cap wear.
X-Torque Cap Adapter is 100% Made in Italy
Via per Ospitaletto, 147 - 25046 Cazzago S.Martino (Brescia) – ITALY
Tel. (0039) 030.7750275 e-mail: [email protected]
Sito web: http://www.carbon-ti.com
cap n°1
2
cap n°2
Scala: 1:1
brand
Roberto V.
Revisione N°
Data
Modifica
RV design s.a.s. di Roberto Vernile & C.
Firma
www.rvdesign.it
DISEGNATO DA
DATA
05/07/2016