Folyon H300 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Ruang iklim Folyon H300. Folyon H300 16 halaman. Temperature humidity chamber
Halaman Cetak•
Press the Infinity Key
Setting Up a Profile (PM6R Only)
For instructions on how to set a profile, see the "EZ-ZONE PM User's Manual", Chapter 7: Profiling Page.
Setup Page Parameters
The setup page parameters below have been programmed into the temperature and humidity controllers at
the factory. These parameters are for reference only and should not be modified.
Improper modifications to these setup values can result in erratic performance and unreliable operation. Do
not attempt to modify the setup values, unless you thoroughly understand what you are doing.
These parameters were saved at the factory under User Settings 1. If these parameters are modified, they
can be restored from the Global Setup Page, User Setting Restore (See the "EZ-ZONE PM User's Manual" for
details.
Analog Input Menu
Parameter
Sensor Type
RTD Leads
Units
Scale Low
Scale High
Range Low
Range High
Process Error Enable
Filter
Input Error Latching
Display Precision
Calibration Offset
Linearization Menu
For the relative humidity controller there are no changes to controller default parameters. For the
temperature controller, each H300 chamber is supplied with its own set of Linearization Menu
settings. These settings are included in a document on the CD that comes with each chamber.
H300 Temperature Humidity Chamber
twice when done.
Display
Temperature
Humidity
Page 11