Cardale safelift Panduan Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pembuka Pintu Garasi Cardale safelift. Cardale safelift 6 halaman. Trackless door gear

Halaman Cetak

www.thegaragedoorcentre.co.uk

safelift

This garage door has been designed to be as easy as possible to use, service and automate

when installed correctly. Please therefore take time to read these instructions fully before

beginning any work. Note: This door is recommended for fitment to a 70mm × 70mm

timber goalpost frame (not supplied). A separate set of instructions should be used if the

door has been supplied pre-fitted to a quick-fit steel frame.

▲

SAFETY FIRST Please read instructions right through before

commencing installation.

CAUTION The spring is under tension – follow instructions carefully

to avoid any chance of personal injury.

IMPORTANT INFORMATION

1 This garage door is intended for domestic use only.

2 Garage doors are heavy and may have sharp edges.

Wear protective gloves. Installation should not be undertaken alone.

Care must be taken when handling.

3 Ensure the door is continuously supported before it is secured and

avoid installing in windy conditions.

4 Do not attempt to install or adjust this door if you are unsure of

any of the instructions below.

5 Wear eye protection.

WARNING

When fitting the multi-point latching do not

shut the door whilst you are outside the

garage until all latches have been correctly

set and tested (See instructions 8 & 9)

Failure to comply could result in being

locked out of the garage and a chargeable

service call will be required.

IMPORTANT NOTES

BEFORE COMMENCING WORK:

a Remove all wrapping including plastic sleeve

from spring. Ensure that your door has been

supplied with the correct main fixing pack

(fixing pack codes are on the identification

label on reverse of door).

Remove lock pack, fixing pack and the black

plastic weather strips from their transit

positions on the rear of the door.

www.thegaragedoorcentre.co.uk

0800 525 442

Trackless Door Gear

INSTALLATION INSTRUCTIONS

b Before fitting the door, check opening size and

squareness of the timber frame. The door is

made smaller to give correct clearance within

the frame.

Also check that the existing timber goalpost

frame is securely fitted to the surrounding

brickwork and is structurally sound.

c There must be a minimum of 65mm (2

headroom above lower face of top timber, or

lintel. This must reach back into the garage for at

least 1300mm (4'3").

d A 70mm × 70mm (2

frame is recommended but the gear only

requires a fitting clearance of 45mm per side.

e All the initial work is carried out from inside

the garage so tools and parts should be to hand

before door is placed in the opening.

f Slots are provided in all key components to

allow for final adjustment, when door has

been installed.

0800 525 442

www.thegaragedoorcentre.co.uk

") timber 'goalpost'