DQ HEATING Moto Horizontal Petunjuk Memperbaiki - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Memperbaiki untuk Pemanas DQ HEATING Moto Horizontal. DQ HEATING Moto Horizontal 4 halaman.
Halaman Cetak
INSTALLATION GUIDE / MOTO
Over – force should
not be applied and
pipe wrench should
not be used during
fixing. Specific care
should be taken into
consideration.
Electric Drill ,
Drill Bit Ø10
Bracket
Bracket lock
x4
x4
DIMENSIONS
Side view
119 mm
65 mm
Z= 110 mm (min.)
Width : W
Height : H
Distance between bracket center : X
Distance between top and bottom bracket center : Y
M-1
Y
Z
(min.)
Do not remove the corner protectors and shrink until all the construction work is complete.
When connecting pipes of various materials, the difference in electrode potential may cause galvanic
corrosion and serious damage.To avoid galvanic corrosion, it is highly recommended to use the same
materials,or materials with similar electric potential, throughout loop.
The wall plugs supplied with your radiator may not be suitable for your wall type.The appropriate wall
plugs should be used by your qualified installer.
Corrosion occurs on heating system components like radiator, valve, pump, etc. due to the oxygen diffusion through pipes,
if the piping system is plastic. In such cases Oxygen barrier pipes should be used. Otherwise, radiators can be corroded and leaked.
Do not apply force
exceeding 18 Nm.
REQUIRED MATERIALS FOR INSTALLATION
Hammer
Metric Ruler
6,3 x 60 mm
10 x 50 mm
Screw
Wall Plug
x4
x4
Rear view
178
178
X
Liquid tread sealant should
be used instead of PTFE
tape or hemp.
Cordless
Screwdriver
Spirit Level
(Bit PH2)
CONTENT OF INSTALLATION SET
Diverter
Air vent
x1
x1
X= W - 356mm
W
C1 AXIS = W + 90mm - 20mm
(Applicable for Tempo valves. For other valves "+90mm" measure will vary)
M-2
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
8,5
max
pH
7,8
m n
or
Cross
Spanner
Point
(8mm)
Screwdriver
Diverter fit-in
Blind plug
plastic tube
x1
x1
178
178
Mark the bracket holes of the product by
measuring them according to the X, Y, Z
Tighten all brackets from the point you marked
by synchronizing with a spirit level.
Attach the plastic bracket
supports to grooves on the
M-3
1
Ph value of the water
used in the system
should be between 7,8
and 8,5.
Stepladder
(For high products)
Mounting bracket
support part
x8
Products with
3 sections
Total of 2 brackets
needed on (One to the
bottom collector and
one to the top collector).
Rear view of 3 sections radiators
M-1
dimensions.
M-2
M-3
brackets.