DR 48" LANDSCAPE RAKE Manual Petunjuk Keselamatan & Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Manual Petunjuk Keselamatan & Pengoperasian untuk Peralatan Rumput dan Taman DR 48" LANDSCAPE RAKE. DR 48" LANDSCAPE RAKE 16 halaman.
Halaman Cetak
Chapter 4: Maintaining The DR 48" LANDSCAPE RAKE
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this Chapter for
maintenance intervals and procedures.
Before performing any maintenance, you must first shut off the tow vehicle, remove the key and set the parking brake.
Regular Maintenance Checklist
P
ROCEDURE
Check general equipment condition e.g., Nuts, Bolts, welds, etc.
Hose down the DR LANDSCAPE RAKE
Check the Tire Pressure
Check condition of Tines
Cleaning the DR Landscape Rake
1.
Use a Hose or Pressure Washer to clean the DR Landscape Rake to keep the Tines, Transport Wheels etc. clean and clear of
debris.
Figure 10
Tines
Carriage
Bolts and
Locknuts
Figure 11
®
DR
10
48" LANDSCAPE RAKE
Checking the Tire Pressure
Tools and Supplies Needed:
Tire Pressure Gauge
Air Compressor
1.
Remove the Valve Stem Protective Cap (Figure 10) and check the tire
pressure with a Tire Pressure Gauge.
2.
Check what the manufacturers recommended pressure is that is stamped on
the side of the Tire.
3.
If the pressure is too low, add air through the Valve Stem with an air hose.
Valve
Stem Cap
4.
Replace the Valve Stem Protective Cap when finished.
5.
Repeat for both Wheels.
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
Tine
Frame
Replacing the Tines
Tools Needed:
17mm Wrench
1.
Use a 17mm Wrench to remove the Carriage Bolt and Locknut that secures
the Tine (Figure 11). Slide the Tine out of the Tine Pressure Plate.
Tines
2.
Slide the replacement Tine into the Tine Pressure Plate and re-secure with
Pressure
the Carriage Bolt and Locknut.
Plates
3.
Repeat for all damaged or worn Tines.
B
E
U
EFORE
ACH
SE
▲
▲
▲
▲