Electrolux # Panduan Servis - Halaman 38

Jelajahi secara online atau unduh pdf Panduan Servis untuk Kulkas Electrolux #. Electrolux # 49 halaman. Over the range microwave oven
Juga untuk Electrolux #: Panduan Petunjuk Instalasi (8 halaman), Panduan Penggunaan & Perawatan (20 halaman), Panduan Penggunaan & Perawatan (36 halaman), Panduan Penggunaan & Perawatan (24 halaman), Panduan Penggunaan & Perawatan (38 halaman), Buku Resep (17 halaman), Buklet Instruksi (12 halaman), Panduan Penggunaan & Perawatan (20 halaman), Buku Instruksi (16 halaman), Buku Instruksi (12 halaman), Panduan Pengenalan (16 halaman), Panduan Pengguna (11 halaman), Panduan Penggunaan & Perawatan (26 halaman), Panduan Penggunaan & Perawatan (38 halaman), Panduan Pemilik (9 halaman), Panduan Penggunaan dan Perawatan (16 halaman), Panduan Penggunaan dan Perawatan (16 halaman), Panduan Petunjuk Instalasi (21 halaman), Panduan Pemilik (16 halaman), Panduan Penggunaan dan Perawatan (16 halaman)

Halaman Cetak

GLMV169GSB

GLMV169GBB

GLMV169GQB

PLMVZ169GCB/C

2. Hold the center of the bracket which supports the shaft

of the fan motor on the flat table.

3. Apply the screw lock tight into the hole (for shaft) of the

fan blade.

4. Install the fan blade to the shaft of fan motor by pushing

the fan blade with a small, light weight, ball peen hammer

or rubber mallet.

5. Install the fan motor to the hood duct with the two (2)

screws.

CAUTION:

* Do not hit the fan blade strongly when installing

because the bracket may be disfigured.

* Make sure that the fan blade rotates smooth after

installation.

. Disconnect the power supply cord.

2. Open the door and block it open.

3. Remove the three (3) screws holding the base cover to

the oven cavity

4. Remove the base cover from the oven cavity by pulling

. Disconnect the power supply cord and remove the oven

from wall and remove outer case. (Refer to procedure

of "Removal of Oven from Wall" and Outer case

Removal")

2. Open the door and block it open.

3. Discharge high voltage capacitor.

4. Remove the hood fan motor and the hood duct from the

oven cavity, referring to the procedure of " HOOD FAN

MOTOR, HOOD DUCT AND OVEN LAMP SOCKET

STIRRER COVER AND STIRRER FAN INSTALLATION

. Put the stirrer fan on the stirrer cover to match the stirrer

fan shaft to the center of the stirrer support.

2. Insert the shaft of stirrer fan to the shaft of stirrer

motor.

3. Insert the cutout of stirrer cover to the tabs on the

ceiling.

4. Install the stirrer cover to the oven cavity, and secure it

by one canoe clip.

. Disconnect the power supply cord.

2. Remove three (3) screws holding the hood exhaust louver

to oven cavity front flange.

3. Remove the hood exhaust louver from the oven by

pushing the right and left tabs of the hood exhaust louver.

(Refer to procedure of "HOOD EXHAUST LOUVER

REMOVAL")

* Make sure that the axis of the shaft is not slanted.

6. Install the hood duct to the oven cavity with the one ()

screw.

7. Re-install the wire leads to the hole of the hood duct.

8. Connect the wire leads to the fan motor and chassis

support, referring to the pictorial diagram.

9. Refer to procedure of "OUTER CASE REMOVAL". And

reverse their procedure. And re-install the outer case.

TURNTABLE MOTOR REMOVAL

down and moving to the left slightly.

5. Disconnect the wire leads from the turntable motor.

6. Remove one () screw holding turntable motor to the

oven cavity.

7. Now the turntable motor is free.

STIRRER MOTOR REMOVAL

REMOVAL".

5. Disconnect the wire leads from the stirrer motor.

6. Remove the two (2) screws holding the stirrer motor to

the waveguide of the oven cavity.

7. Remove the stirrer motor from the waveguide.

8. Now, the stirrer motor is free.

9. When installing the stirrer motor, the shaft of stirrer

motor must be inserted to the stirrer fan shaft. Refer to

the procedure of "STIRRER COVER AND STIRRER

FAN INSTALLATION".

OVEN LAMP REMOVAL

4. Lift the oven lamp cover up.

5. Now, the oven lamp and the socket are found.

6. Screw the oven lamp off from the lamp socket.

7. Now, the oven lamp is free.

Shaft

Table

Center of

bracket

Shaft

Stirrer Fan

Stirrer Cover

Canoe Clip