Electrolux 1458528 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kulkas Electrolux 1458528. Electrolux 1458528 30 halaman. Side by side refrigeration
Halaman Cetak
General Installation
When correctly installed, your refrigerator should:
• have adequate clearance to the back, sides and top
for air circulation.
• be aligned to the surrounding cupboards
• have doors that will self close from a partially open position
caution
Automatic aerosol systems (such as insect control) should not
be located adjacent to the product as the spray may cause
long term damage to the external plastics of the appliance.
Clearances around your refrigerator
Your Side by Side Refrigerator can be installed between
cupboards or fixtures but you must allow for the following
spaces around the cabinet.
• allow a minimum of 5 millimetres clearance on both sides
(refer to diagram 1).
• allow a minimum of 10 millimetres clearance above
hinge covers (refer to diagram 1).
• allow a minimum of 10 millimetres at the back of the
refrigerator (refer to diagram 1).
10mm
35mm
Recommended
airspace
CABINET
• allow a 250 or 350 millimetres clearance on the hinge side
10mm
of the doors, if you place the refrigerator next to
10mm
35mm
the wall. This will make cleaning easier (refer to diagram 2).
Freezer
Door
Recommended
airspace
• make sure that cupboards or fixtures do not stick out further
than the refrigerator cabinet.
CABINET
Diagram 2
Freezer
Door
Installation
The refrigerator should arrive with the front rollers wound down.
We recommend that the refrigerator be tilted backwards by
about 10 to 15 millimetres, this will allow the doors to self
close providing a consistent door seal. To do this follow the
instructions below.
10-15mm
Height adjustable
front rollers
890mm
890mm
90°
Diagram 1
10mm
90°
DOORS
Fridge
Door
DOORS
Note: Doors are designed
to sit proud of cabinetry
(not flush). the clearances
Fridge
Door
shown above are the
recommended minimum
clearances.
Fixed rear
rollers
electrolux side by side refrigeration installation 3
When you want to install your refrigerator, take the
following steps.
1. Roll the refrigerator into it's final position.
warning
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and
the rollers.
2. If the refrigerator is not tilted back you can adjust the
two front rollers by adjusting the large plastic roller nut
(refer page 3). You may need two people, one to adjust
rollers and one to tilt the refrigerator slightly back to
take the weight of the appliance off the front rollers.
This will increase or decrease the height of the rollers.
One turn of the nut will change the tilt of the refrigerator
by approximately 10mm.
3. If the cabinet is level, then the side walls should be plumb
or vertical. If the cabinet is built in or partly built in check
the alignment of the cabinet side against the cupboard.
aligned to cupboard –
even gap
4. If the appliance now rocks from one corner to the opposite
rear corner, this means that the floor is uneven; you will
need to put some packing under one of the rear rollers.
5. You may now need to fine-tune the installation by
adjusting the front rollers once again.
Top of refrigerator
is level – horizontal
Adjust front rollers for
unevenness of floor.
eg. adjust this roller down.
Packing may be required
underneath the rear roller
to ensure stability.