Bosch AquaStar 6.0L Panduan Petunjuk Pengoperasian - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin pencuci piring Bosch AquaStar 6.0L. Bosch AquaStar 6.0L 30 halaman. Dishwasher 60cm , activewater white aquastar 6l, exxcel
Halaman Cetak
en
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display )*.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
– Close the door.
– Switch on ON/OFF switch (.
– Press button X + until the digital
display )* jumps to :
– Press X + or – button until the
displayed time corresponds with your
requirements.
– Press START button h, timer
programming is activated.
– To delete timer programming, press
the X + or – button until )* :
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value :
is indicated on the numerical
display )*.
18
Switching off automatically after
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from
:
:
:
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
.
– Release both buttons.
– Press programme button # until the
is
To change the setting:
– Press programme button 3.
– Press START button h.
Switching off the appliance
Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
– Remove the utensils when they have
ã=
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
:
to :
.
Appliance does not switch off
automatically
Off after 1 min
Off after 120 min
press START button h until : ... is
indicated on the digital display.
The LED for button # flashes and the
digital display )* displays the factory
setting :
.
factory set value :
the digital display )*.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
The set value is saved.
Stop fitted).
cooled down.
Warning
is indicated on
has been reached,
(off).