Bosch Integra 500 Series Buletin Layanan
Jelajahi secara online atau unduh pdf Buletin Layanan untuk Mesin pencuci piring Bosch Integra 500 Series. Bosch Integra 500 Series 2 halaman. Replacing primary fan & main burner
Juga untuk Bosch Integra 500 Series: Buletin Layanan Teknis (3 halaman)
![Bosch Integra 500 Series Buletin Layanan](/uploads/products/server2/1329770/1329770.jpg)
Service Bulletin G3-24
Models: 715ES, C800ES, 2400ES, 2700ES, Evolution 500, Integra 500
Replacing the control unit
Introduction
Tools needed:
Phillips head screw driver
Small flat head screw driver
Needle-nosed pliers
Note: Avoid touching printed circuit board (PCB) as static discharge
may damage circuitry.
Preparation
Push power button to "OFF" and unplug power cord.
Loosen two Phillips head screws on bottom rear of front cover.
Pull cover bottom outwards then lift cover upwards to remove.
Removing control unit
Remove three Phillips screws on front of control unit. (Fig. 2,
pos. 1)
Turn control unit to expose the rear. (Fig. 2, pos. 2).
Locate and remove 6 Phillips head screws on back of control
unit (Fig. 2, pos. 3).
control unit front
control unit front
3
3
Remove rear cover from control unit to expose circuit board
electrical connections. Slide wire restraints out of control unit.
(Fig. 3, pos. 1).
Remove two large electrical strip connectors by pulling them
away from board. (Fig. 3, pos. 2).
Remove medium sized electrical strip connector by pulling it
outwards. (Fig. 3, pos. 3).
Remove small electrical strip connector by pulling it outwards.
(Fig. 3, pos. 4).
Remove two large ignition wires by pulling them outwards.
(Fig. 3, pos. 5).
Remove yellow/green striped ground wire spade connection by
depressing tab on connector and pulling it gently off the board.
(Fig. 3, pos. 6).
Loosen two small flat head screws on terminal block for power
cord. Pull black and white wires free from terminal block and
control unit. (Fig. 3, pos. 7).
Loosen Phillips head screw and remove green ground wire con-
nection for power cord. (Fig. 3, pos. 8).
Figure 2
2
1
Remove control unit from the water heater.
Appliance evaluation for PCB jumper location
3
3
Please evaluate the following prior to installation of the replacement
PCB:
3
2
4
6
8
1
Figure 3
7
5
1