Bosch SGE63E15UC/51 Panduan Petunjuk Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring Bosch SGE63E15UC/51. Bosch SGE63E15UC/51 37 halaman.

Halaman Cetak

For a large port, use the drain hose as it is.

For a small port, insert the rubber drain hose adaptor

into the drain hose end.

Obtain the Rubber Drain Hose Adaptor (J) spring clamp

from the Dishwasher Installation Kit (do not substitute).

Insert the dishwasher

drain hose into the end of the

drain hose (see Figure 15). Be sure to fully insert the

drain hose.

Use the clamp provided to attach the Rubber Drain Hose

Adaptor to the house plumbing as shown in Figure 16.

Figure 15

Top Mount is used for countertops made of wood or other

materials that can be easily drilled. Orient the mounting

brackets as shown in Figure 17, and position the two small

tabs on the mounting brackets over the two slots on the dish-

washer's front corners. Push the mounting brackets down

firmly to insert the tabs into the slots.

Figure 16

Top Mount

Figure 17

Side Mount is used for countertops made of marble, granite,

or other very hard materials that cannot be easily drilled.

Bend the mounting brackets

along the small holes and in

the same direction as the two small tabs. Orient the mounting

brackets as shown in Figure 18, and position the two small

tabs on the mounting brackets over the two slots on the

dishwasher's

front corners.

Push the mounting

brackets

down firmly to insert the tabs into the slots. Bend perforated

edge down as shown.

Before installing the supplied

countertop

mounting

brackets,

decide

which

method

of securing

the

dishwasher

into its enclosure will be used. Once the

mounting

brackets are installed on the dishwasher,

removing

them

is difficult

and will

damage

the

mounting

brackets

and the dishwasher.

The dishwasher can be secured into its enclosure in 3 ways:

NOTE: If your dishwasher opening width measures >23%"

(600mm) use the TOP or SIDE MOUNT mounting methods.

If your dishwasher opening width measures 23%" (600mm)

use the ALTERNATE

SiDE MOUNT mounting method.

Side Mount

Figure 18

Alternate

Side Mount for opening 235/8" (600mm). Insert

a side mount force distributor (M) in each side as shown in

Figure 19.

Figure 19

Alternate Side Mount