Bosch SGS43T82 Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mesin pencuci piring Bosch SGS43T82. Bosch SGS43T82 18 halaman.

Halaman Cetak
en
... when the appliance is
switched on
The appliance does not start.
-
The mains fuse has tripped.
-
The appliance plug has not been
inserted.
-
The appliance door has not been shut
properly.
... on the appliance
Lower spray arm rotates sluggishly.
-
Spray arm blocked.
The door is difficult to open. *
-
Child-proof lock is activated.
The deactivation instructions
are at the back in the envelope.
* depending on model
Cover on the detergent dispenser cannot
be closed.
-
Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
-
Dispenser was damp when filled.
Refill indicator for salt[]] and/or rinse-
aid
rn
is not lit.
-
Refill indicator/s switched off.
-
Adequate salt/rinse-aid available.
Refill indicator for special salt[]] is lit.
-
No salt.
Refill with special salt.
"Tap _.., display is lit
-
Tap turned off.
20
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
-
Switch off the appliance and pull
out the mains plug.
-
Turn off the tap.
-
Clean filter in the supply hose.
+
+
-
Reconnect power supply.
-
Turn on the tap.
-
Switch on the appliance.
Water is left in the appliance at the end
of the programme.
-
Waste water hose
is blocked or kinked.
-
Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Waste water pump).
-
Filters blocked.
-
The programme has not yet ended.
Wait until programme
ends or implement "Reset"
function.
... during the wash cycle
Unusual foam formation.
-
Handwash liquid in the rinse aid
dispenser.
Spilled rinse aid causes excessive
frothing, therefore please remove with
a cloth.
Appliance stops during the wash cycle.
-
Power supply interrupted.
-
Water supply interrupted.
Filling valves making striking noises
-
Caused by the installation of the water
line and has no effect on the function
of the machine. Remedial action is not
possible.
Knocking/rattling noise during rinsing
-
Spray arm is striking utensils.
-
Utensils not arranged correctly.
As soon as the rinse-aid refill
indicator[[] is lit on the fascia, there
is still a rinse-aid reserve of
1-2
rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers .
Combined detergents with rinse-aid
component may be used up to a water
hardness of
21
o
dH (3JC fH,
26°
Clarke,
3.7 mmol/1) only. If the water hardness
is over
21
o
dH, rinse aid must be used.
Open the cover on the rinse-aid
dispenser []ill. To do this, press
the mark ( 1) on the cover
and simultaneously lift
the cover on the control plate (2).
-
Carefully pour in the rinse aid to just
below the edge of the filler opening.
-
Close cover until it clicks shut.
-
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The rinse aid dispensing rate can be
adjusted steplessly. The clear rinse
controller was set to 4 at the factory.
en
Do not change the position of the rinse aid
control unless there are streaks (rotate
towards -) or water stains (rotate towards
+)on the utensils.
9