Dragonfly Rio Mobility Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kursi roda Dragonfly Rio Mobility. Dragonfly Rio Mobility 10 halaman.

The Dragonfly

is compatible with almost all wheelchairs without the need for any special

adapters.

Wheelchair

Frame

Configuration

Wheelchair

Frame Tube

Diameter

Anti-Tips

and

Seatbelts

Weight

RULER MUST BE PRINTED AT 100%

NO SCALING - RULER IS 6"(152mm) LONG CUT

AND WRAP AROUND TUBE, check with a ruler

1. Wheelchair Requirements

For a complete listing of compatible wheelchairs, visit

riomobility.com. If your wheelchair is not listed, please contact

customer service at [email protected].

The Dragonfly

can accommodate chairs of seat width 35.5 cm-

55.8 cm / 14 inches-22 inches. If your chair falls outside this range,

contact customer service.

The frame tube diameter must be either:

22.2 mm / 7/8 inch, 25.4mm / 1 inch, 28.6mm / 1

30.5mm / 1.2 inch, or 31.8mm / 1.25 inch

If your tubing is a different shape or diameter contact

If you do not know the diameter of your tubing, contact your

wheelchair manufacturer or dealer, or cut out the ruler printed below

to measure. Wrap the ruler around your tubing and note where the

markings line up.

When seated in the wheelchair, your center of gravity must be

far enough forward to prevent tipping backwards. IMPORTANT:

If the chair is set up such that "wheelies" are easy, it may be too

unstable to attach or detach the handcycle. Anti-tips MUST be

installed on your wheelchair. A seat belt is also strongly

recommended.

Combined wheelchair and user weight must be less than 130kg/280lb.

ALONG DASHED LINE

7/8"

1.2

FOR WIDTH OF RULER

125 inch

FRAME MUST BE STRAIGHT