Dragster DDM Series Panduan Instalasi dan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Penguat Dragster DDM Series. Dragster DDM Series 8 halaman.

Halaman Cetak

General Description

1
11
COOLER: The fans work when the device is turned on. They provide device cooling.
1
10 15
2
INPUT: This input should receive the signal through an RCA cable connected to the output of the
receiver or player.
3
OUTPUT: This output can be used optionally to play another amplifier, facilitating installation in multi-
amplified systems.
4
LEVEL: Controls the input signal level, allowing for proper control of any receiver or player. It can be
regulated as the following:
A) on the receiver or player, play any musical signal up to 80% volume.
(Ex: If the maximum volume on the player is 45 [100%], adjust to 36 [80%]).
B) on the amplifier, beginning at the lowest LEVEL, gradually increase until the LED "OVER CLIP"
begins to flash.
C) slowly decrease the LEVEL until the LED "OVER CLIP" goes off.
L.P.F (LOW PASS FILTER): Controls the low pass point for the speaker outputs. It is regulated from
5
50Hz to 15KHz).
FREQUENCY (BASS BOOST): Adjustable control for boosting low frequency ranges from 40 to 120Hz.
6
GAIN (BASS BOOST): Gain adjustment control from 0 to +12dB at the frequency set at bass boost.
7
OVER CLIP (ON/OFF): With this key turned on, the LED "OVER CLIP" will light up at 15% more final
8
capacity.
2
3
4
5
16
12
6
7
8
17
18
13
14
3
9
10
15