Bosch SRV53C03UC-30 Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring Bosch SRV53C03UC-30. Bosch SRV53C03UC-30 15 halaman. 18-inch models

Halaman Cetak

Plumbing Preparation

INLET

WATER

CONNECTIONS

Avoid Scald Hazard

Do not perform any work on a charged hot water

line. Serious injury could result. Only qualified

plumbers should perform plumbing work. Do not

attempt any work on the dishwasher

hot water

supply plumbing until you are certain the hot

water supply is shut off.

Temperatures

required for soldering and sweating

will damage the dishwasher.

If plumbing lines are

to be soldered or sweated, keep the heat

source at least 6 inches (152.4 mm) away from

the dishwasher.

Hot Water Supply

The hot water heater should be set to deliver

approximately

120 ° F (49 ° C) water to the dishwasher,

Water that is too hot can cause some detergents to lose

effectiveness.

Lower water temperatures

will increase run

times, The hot water supply pressure must be between

15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

If using a solder joint instead of a compression

fitting,

be sure to make al! solder connections before connect-

ing the water supply line to the dishwasher.

Make sure there are no sharp bends or kinks in the

water line that might restrict water flow.

Always use the appropriate

seal when making plumb-

ing connections,

Before connecting the water supply _ine to the dish-

washer, flush it to clear any foreign material.

Turn on the water supply and check for leaks after

connections are made,

Do not use pipe sealant on compression

fittings.