Dramm Autofog MLVH-10A Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyemprot Cat Dramm Autofog MLVH-10A. Dramm Autofog MLVH-10A 20 halaman.

Halaman Cetak

Spraying Procedure

1. Vacate the treatment area, secure all entry ways

and post hazard signs.

2. Prepare the chemical solution. See page 10 for

dilution rate details. Be sure that the solution is

free of clumps of chemical that may clog the

nozzle. Use a whisk or blender to make a smooth

paste of wettable powder solutions. Check that

the suction tube screen is in place in the tank.

Pour the solution through the large solution

strainer/ funnel assembly to eliminate any unmixed

chemical or debris.

3. Plug in the main power cord. Notice the power

lamp illuminated on the control panel.

4. Set the timer. Turn the dial past, then return to

the desired operation time. The MLVH-10A will

begin to spray, vacate the treatment area

immediately.

5. If horizontal airflow fans are used, allow them to

run a half hour longer than the predetermined

spray time.

6. In order to allow all of the spray particles to settle,

do not re-enter the treatment area for a minimum

of 6 hours after the MLVH-10A has completed its

operation. Keep the structure airtight. However, if

it is necessary to enter the treatment area during

application, only do so in a full spray suit, boots,

gloves, hood and respirator.

7. After spraying, ventilate the treatment area with

fresh air and clean the MLVH-10A thoroughly.

Follow all EPA Guidelines for re-entry.

DISCHARGE TIMES FOR MLVH-10A

Clear Water

1.0 liter

2.0 liters

3.0 liters

4.0 liters

5.0 liters

6.0 liters

7.0 liters

How To Set The Timer

1. Plug the AutoFog into the appropriate power

2. Set the clock to the correct time. The timer is a 24

3. Determine the spray starting time and stopping

4. Flip ALL of the pins between the starting and

5. The AutoFog will run only during the time that the

6. The AutoFog is now ready and will begin fogging at

NOTE:

Time

30 minutes

1 hour

1.5 hours

2.0 hours

2.5 hours

3.0 hours

3.5 hours

Timer Settings

The MLVH-10A should be allowed to run for a half

hour after all chemical has been expelled into the

air. See the chart below for approximate amount

of time it takes to expel chemicals. These times

were compiled with clear water - the expulsion

time time may exceed these guidelines when

mixed with chemicals.

Times may vary due to the consistency of solution

being sprayed. Thicker solutions

may take longer to discharge.

source.

hour timer for accuracy between day and night.

time.

stopping time to the OUTSIDE. (see photo below)

pins are flipped to the outside of the clock. DO

NOT FLIP THE START TIME AND STOP TIME

ONLY. Each pin represents 15 minutes of time.

the appropriate time. Make sure the treatment

area is secure and will be empty of all personnel at

that time.

Remember to add a half hour to the spraying time

when setting the timer.

Dramm Autofog MLVH-10A Manual

A video on programming

your timer is available on

our website.