Dramm FM20 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyemprot Cat Dramm FM20. Dramm FM20 16 halaman. Foamer
Juga untuk Dramm FM20: Panduan Pemilik (8 halaman)

Halaman Cetak

1. Always wear safety goggles and protective gloves while operating foam unit.

2. Avoid contact of cleaning agents with skin and eyes. If contact occurs rinse affected area with

water for 15 minutes and get medical attention if needed.

3. After use, relieve all remaining pressure in the system by unplugging the air line from the unit and

opening the discharge ball valve.

4. Incoming air pressure cannot exceed 100 psi.

5. Never point the discharge ball valve at anyone.

6. Be sure to flush the unit with fresh water for 5 minutes when switching from an alkaline to an

acid or an acid to an alkaline.

1. Remove all parts from shipping box.

2. Clip the cable tie holding the air fitting, cotter pins, and axle washers from the leg of the cart.

3. Place one of the washers on one of the axles, then slip a wheel on the axle followed by a second

washer, then insert a cotter pin into the hole in the axle and bend the cotter pin to keep it from

falling out. Repeat this for the other side.

4. Screw the air plug into the brass fitting on the side of the control box. Be sure to hold the brass

fitting while turning the air plug. Do not over–tighten.

Because there are a number of different air fitting standards available, Dramm foamers do not come

with a pre-installed air fitting. The air inlet offers both 1/4" female pipe thread and 3/4" male pipe

thread as connection options for your fitting.

1. Choose an air fitting that matches those on your compressor outlet.

2. Apply teflon tape or pipe sealant to the thread and install.

Foamer Manual

SAFETY INSTRUCTIONS

SET – UP INSTRUCTIONS

AIR FITTING