Dramm HYDRA-ST50 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyemprot Cat Dramm HYDRA-ST50. Dramm HYDRA-ST50 20 halaman.

SPRAY OPERATION

1. After following the start up, to increase the

spray pressure, turn the pressure control

knob to the desired setting. (B) You may

use any of these settings for spraying, as

the unit will operate properly at all settings.

2. To begin spraying, pull the lever to the gun.

A latch is provided to hold the level open

to reduce operator fatigue. (C)

CAUTION

Do not direct the spray at

yourself or others, as injury may occur. On

higher pressure settings, the spray stream

may cut or inject spray under your skin.

Always wear proper personal protective

gear when spraying.

3. Spray Pattern: Adjustment of the spray

pattern is made using the lever on the side

of the gun. The pattern will adjust from a

straight stream to a fine cone mist. (D)

4. Hose Reel: The Hydra MultiSpray comes

standard with a variable drag lockable

hose reel. The reel may be locked in

position to prevent the hose from

unwinding further than wanted. (E) The

variable drag on the reel places variable

tension on the reel to prevent freewheeling

of the reel during unwinding. The drag has

a lever to activate it. A nut allows for

tension adjustment. (F)

SHUT?DOWN

1. After spraying until the tank is empty, turn

the unit off.

2. Add clear water to the tank. Start the

machine and spray until empty flushing

out the pump hose and gun.

3. Clean any residue from the unit.

4. Return the regulator to the START position.

5. Store the unit in a clean dry place.

6. Do Not allow the unit to freeze as any

water left in the unit will expand and

damage the machine.

Operation

Hydra Sprayer