Bosch 8 Series Petunjuk Instalasi dan Penggunaan Manual - Halaman 14

Installation

Insert the two bolts on the ceiling through the

openings provided in the frame

to allow the bolts to be screwed into the keyhole

openings

Use two more bolts to screw the frame in place.

Tighten all the bolts fully.

Insert the four cables into the openings provided in

the frame and thread them through the labyrinth.

. Move the frame

Establishing a connection to the mains

Warning

Risk of electric shock!

It must always be possible to disconnect the appliance

from the power supply. If there is a fixed connection, an

all-pole isolating switch with a contact gap of at least

3 mm must be provided for the wiring. Only an

electrician may install the fixed connection.We

recommend installing a residual-current circuit breaker

(RCCB) in the appliance's power supply circuit.

To find out the correct fuse rating, see the total

Note:

connected load (in watts) on the appliance's rating

plate.

Position the appliance underneath the frame.

Carefully thread the cables and the mains power

cable through the opening in the frame cover. Place

the frame cover down onto the appliance.

Mount the appliance on the wall and level it; see the

section entitled "Wall-mounting the appliance and

levelling it".

Thread the mains power cable through the opening

in the frame and then through the strain relief.

Caution!

Do not position the mains power cable that is inside

the frame underneath the frame.

Connect the appliance to the power supply.

Caution!

Pay attention to the marks on the connection

terminals when connecting the wires (permissible

cross sections of the domestic wiring: 1 mm² -

2.5 mm²) in the mains power cable.

Use an open-ended spanner (WAF 17) to tighten the

strain relief until the mains power cable is held firmly

and cannot move.