Bosch Classixx 1200 Panduan Instalasi Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Instalasi Cepat untuk Mesin cuci Bosch Classixx 1200. Bosch Classixx 1200 12 halaman. Washing machine
Juga untuk Bosch Classixx 1200: Panduan Cepat (4 halaman), Panduan Instalasi (24 halaman), Buku Petunjuk (48 halaman)
Halaman Cetak
4
en | Introduction
1
Introduction
The following installation describes how to use the Bosch DLA disk array series (1200/1400
series) as standard iSCSI disk array.
The system is pre-installed with the Bosch Video Recording Manager (VRM). Using the system
as standard iSCSI disk arrays, you must disable the VRM Service.
2
Setup Instruction
All Bosch DLA Series disk arrays are preconfigured with a default IP address and with default
iSCSI settings.
–
–
–
–
Detailed information, such as data sheets and user manuals, are available on the Bosch web
site www.boschsecurity.com under Product Catalog > CCTV > IP Video > Disk Arrays.
Default iSCSI settings are optimized for use with VRM. Only an experienced storage
administrator should make changes to these settings. Changing the default configuration is
only required either if VRM is not used or if the default settings are not appropriate for
another Bosch iSCSI application.
3
Setting the IP Address
The default IP address may be changed by either of two ways.
3.1
Remote Desktop Connection
1.
2.
3.
4.
- | V1 | 2011.02
IP Address: 10.10.10.10 (1st port) and 10.10.10.11 (2nd port)
Net mask: 255.255.255.0
User: Administrator
Password: WSS4Bosch
Connect the system to your network through port 1 or port 2 and start up the system.
The system comes with the Remote Desktop Connection enabled. Log on to an
appropriate Client system either with Windows XP, Windows Vista or Windows 7
installed (Client hardware and software is not part of the shipment) with an IP Address in
the same network, e.g. 10.10.10.12 (net mask: 255.255.255.0).
Open the Remote Desktop Connection on your client system. In the Computer box,
enter the IP Address of the disk array you want to connect to.
Default IP Address: 10.10.10.10 (port 1)
Click Connect, press Ctrl+Alt+Del (if shown), then type the default password
WSS4Bosch once the disk array login window is displayed.
On first login the desktop default settings are applied. This will take a few seconds and
the system will reboot. After system reboot, log on again and the Bosch VRM Appliance
Quick Installation Guide
1200/1400 Series as standard iSCSI disk array
Bosch Sicherheitssysteme GmbH