Bosch FAP-OC 500Series Panduan Servis - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Servis untuk Mesin cuci Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 36 halaman. Built-in wall ovens
Juga untuk Bosch FAP-OC 500Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Penggunaan Manual (40 halaman), Panduan Instalasi (6 halaman), Informasi Produk (40 halaman), Panduan Instalasi (28 halaman), Panduan Pengguna (48 halaman), Panduan Pengguna (48 halaman), Panduan Instalasi (28 halaman), Panduan Penggunaan dan Perawatan (44 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan (40 halaman), Panduan Referensi Cepat (4 halaman), Panduan Penggunaan dan Perawatan (27 halaman), Panduan Instalasi (24 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan (24 halaman), Panduan Instalasi (28 halaman), Panduan Servis (41 halaman), Panduan Penggunaan dan Perawatan (21 halaman), Panduan Instalasi (32 halaman), Panduan Instalasi (32 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

After installing a new user interface board, always reset the oven and

test.

4.9

PC Control Module (Relay Board)

To access the PC control module, pull the unit out from the wall 15-16

inches, and remove the access panel (3 T20 screws) on the top of the

unit. See Figure 14.

Figure 14 PC Control Module is visible after removing access panel.

Whenever possible, conduct troubleshooting tests at the control

module. Refer to Figures 15 -16 for plug and relay locations.

Rear

X102

X101

X103

X110

X210

X204

X202

X201

X203

Front

Figure 15 Plug locations on the double oven control module

X105

X106

X107

X104

X209

X207

X205

X206

Figures 16 Relay locations on the double oven control module

NOTICE

More than 75% of the control modules returned to the factory are fully

functional. Before diagnosing a bad control module, be sure to

disconnect and reconnect each wire/wire harness.

Service Manual for Bosch Built-in Wall Ovens

Page 15 of 36