Draper Nocturne+ E Petunjuk Pemasangan & Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Pengoperasian untuk Layar Proyeksi Draper Nocturne+ E. Draper Nocturne+ E 12 halaman. Outdoor electric projection screen

Halaman Cetak

Nocturne+ E

Section 2 - Mounting Case with Brackets - Wall Installation

Section 2.1 - Attaching Mounting Brackets

1. Attach mounting brackets to wall using #10 ﬂat head screws installed ﬂush with bracket.

Be sure to use AT LEAST 2 of top mounting holes

Section 2.2 - Attaching Case to Mounting Brackets

1. Attach Case to brackets and tighten Set Screws

2. Proceed to Section 4

(Installing Cable Guides)

Figure 3

Section 3 - Mounting Case Directly to Ceiling or Wall

1. Attach Mounting Brackets to Case as a spacer between Case and wall.

Please Note: Leave a 1¾"

(44mm)

, and tighten set screws.

(Fig. 4)

2. Remove roller assembly.

A. Remove screws from bottom of Case, remove Cover and set aside

B. Remove Quick Release Pin from Idler End of Roller Assembly.

C. Remove Roller Assembly, Idler End ﬁrst, and set aside.

3. Mount to Ceiling / Wall.

A. Using mounting holes in endcaps as a guide

both ends of Case.

B. Attach to mounting surface using appropriate fasteners.

Please Note: Installer is responsible for selecting mounting hardware

appropriate for site conditions.

4. Once Case is secured to mounting surface, re-install Roller Assembly,

Quick Release Pin and Cover.

5. Proceed to Section 4

(Installing Cable Guides)

Remove

cover.

Remove quick

release pin.

(Fig. 2)

(Fig. 3)

gap between Endcap and Mounting Bracket

, drill pilot holes on

(Fig. 6)

Figure 5

Remove roller

assembly.

Remove screws from

bottom of case.

Tighten

set screws.

Figure 4

(Fig. 5)

Leave a 1 "

gap.

(44mm)

page 3 of 12

Figure 2

Attach

mounting bracket

as spacer and

tighten set screws.

Figure 6

CEILING

MOUNT HOLES

WALL

MOUNT HOLES