Bosch WAE24367BY/30 Buku Petunjuk - Halaman 8
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin cuci Bosch WAE24367BY/30. Bosch WAE24367BY/30 8 halaman.
What to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
– Inicio/Pausa + Carga (Start/Reload) not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door cannot
– Safety function active. Programme stopped?
be opened.
– Is
(without final spin) selected?
– Can be opened by emergency release only?
Programme does not start.
– Inicio/Pausa + Carga (Start/Reload) or
selected?
– Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is not
– Is
(without final spin) selected?
drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the drum. – Not a fault - water below the visible area.
Unsatisfactory spin result.
– Not a fault - the unbalanced-load detection system has cancelled the spin cycle
Laundry wet/too damp.
because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
–
Fácil (Easy-Iron) selected?
– Selected speed too low?
The programme duration
– Not a fault – the programme sequence is optimised for the particular wash process.
changes during the wash
This may result in changes to the programme duration in the display field.
cycle.
Spin cycle performed several
– Not a fault - unbalanced load detection system adjusts the imbalance.
times.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme Algodón/Algodão (Cottons) 90 °C without laundry. Use standard
washing machine.
detergent.
Status display
flashes.
– Too much detergent used? Mix 1 tablespoon of fabric softener with ½ litre of water
Foam may be coming out of the
and pour into dispenser II (not for outdoor and down-filled textiles!).
detergent drawer.
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and "wandering"
Secure the appliance feet
during the spin cycle.
– Transportation safety devices removed? Remove the transportation safety devices
Installation instructions.
Noises during spin and drain
– Clean detergent-solution pump
cycles.
Display panel/indicator lamps
– Power cut?
do not function during
– Fuses triggered? Reset/change the fuse.
operation.
– If the fault occurs repeatedly, call customer services.
Programme sequence longer
– Not a fault - unbalanced load detection system adjusts imbalance by repeatedly
than usual.
distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse cycle.
Detergent residues on the
– Occasionally, phosphate-free detergents contain water-insoluble residues.
laundry.
– Select the
washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Stop (Off) and remove the mains plug from the socket.
– Turn off the water supply and call customer services
page 10.
page 4.
page 3, 4.
page 9.
Fin diferido (Finished in) time
page 5.
page 3, 4.
page 10.
page 5.
page 5.
page 9.
Installation instructions.
page 10.
(Rinse)/Centrifug. (Spin) cycle or brush out the laundry after
Installation instructions.
Washing machine
en Instruction manual
11