Bosch WAE24461GB Buku Petunjuk dan Petunjuk Instalasi - Halaman 20
Jelajahi secara online atau unduh pdf Buku Petunjuk dan Petunjuk Instalasi untuk Mesin cuci Bosch WAE24461GB. Bosch WAE24461GB 40 halaman. Bosch wae24461gb washing machine
Juga untuk Bosch WAE24461GB: Buku Petunjuk dan Petunjuk Instalasi (40 halaman)
Halaman Cetak
Operating the appliance
en
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the A Start/Reload
button.
The A Start/Reload indicator light
flashes and the machine checks
whether it is possible to add laundry.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If, in the display panel:
Both the YES and ¼ symbols light
■
up, it is possible to add laundry.
NO flashes, wait until the YES and ¼
■
light up.
Do not open the washing machine
door until both the YES and ¼
symbols are lit.
NO lights up, it is not possible to add
■
laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry
during this time.
To continue the programme, press
the A Start/Reload button. The
programme continues automatically.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select the other programme.
1.
Press the A Start/Reload button.
2.
The new programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
Cool down laundry: Select O Rinse.
1.
20
Press the A Start/Reload button.
2.
For programmes at low temperatures:
Press A Start/Reload.
1.
Select 0 Spin or [ Drain.
2.
Press the A Start/Reload button.
3.
Programme end during rinse
hold
$ (without final spin) appears in the
display panel and the A Start/Reload
button indicator light flashes.
To end the programme, set the
programme selector to O Rinse/[
Drain or select a spin speed. Then
press the A Start/Reload button.
Programme end
-0- appears on the display panel and
the "Start/Reload" button indicator lamp
flashes.
If the N symbol also appears on the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.