Bosch wae28462gb Buku Petunjuk dan Petunjuk Instalasi - Halaman 34

Jelajahi secara online atau unduh pdf Buku Petunjuk dan Petunjuk Instalasi untuk Mesin cuci Bosch wae28462gb. Bosch wae28462gb 36 halaman.

Positioning and connecting
en
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
correctly installed and connected
(from ~ Page 28).
Never use a damaged machine.
Inform the after-sales service.
~ Page 27
Check the washing machine.
1.
Connect the mains plug.
2.
Turn on the tap.
3.
Switch on the appliance.
4.
Close the washing machine door (do
5.
not load any laundry).
Select the Cottons 90 °C
6.
programme.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Add standard detergent to
9.
compartment II according to
manufacturer's instructions for light
soiling.
To prevent foaming, only use
Note:
half the recommended amount of
detergent. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
10.
Press the Start button.
11.
Switch off the appliance when the
12.
programme has finished.
Your washing machine is now ready to
use.
34

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose.
Drain the remaining detergent
3.
solution.
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if necessary.
Insert all four sleeves.
2.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
The transport locks must be
removed.
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Drain programme.