Draper 83611 Petunjuk Manual - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Alat Listrik Draper 83611. Draper 83611 20 halaman. Biscuit jointer
Juga untuk Draper 83611: Manual (20 halaman)

Halaman Cetak

HEALTH & SAFETY INFORMATION

–

Care shall be taken when mounting tools to ensure that the clamping is by the hub of

the tool and that the cutting edges are not in contact with each other or with the

clamping elements.

–

Fastening screws and nuts shall be tightened using the appropriate spanners, etc., and to

the torque value provided by the manufacturer.

–

Extension of the spanner or tightening using hammer blows shall not be permitted.

–

Clamping surfaces shall be cleaned to remove dirt, grease, oil and water.

–

Clamping screws shall be tightened according to instructions provided by the

manufacturer. Where instructions are not provided, clamping screws shall be tightened

in sequence from the centre outwards.

–

Use of loose rings or bushes to "make up" bore sizes on circular saw blades shall not be

permitted.

–

Use of fixed rings, e.g. pressed or held by adhesive fixing, in circular saw blades or

flanged bushes for other tools shall be permitted if made to the manufacturers

specification.

–

Resin shall only be removed from light alloys with solvents that do not affect the

mechanical characteristics of these materials.

Repair of tools

–

Repair of tools is only allowed according to the tool manufacturers instructions.

Particular attention is drawn to the following.

–

The design of composite (tipped) tools shall not be changed in the process of repair.

–

Composite tools shall be repaired by a competent person, i.e. a person of training and

experience, who has knowledge of the design requirements and understands the levels

of safety to be achieved.

–

Repair shall therefore include, e.g. use of spare parts which are in accordance with the

specification of the original parts provided by the manufacturer.

–

Tolerances which ensure correct clamping shall be maintained.

–

For one piece tools care shall be taken that regrinding of the cutting edge will not cause

weakening of the hub and the connection of the cutting edge to the hub.

5.3 CONNECTION TO THE POWER SUPPLY

Make sure the power supply information on the machine's rating plate are compatible with

the power supply you intend to connect it to.

This product comes supplied with a UK standard 3 pin plug fitted. It is designed for

connection to a domestic power supply rated at 230V AC.

This appliance is Class II† and is designed for connection to a power supply matching that

detailed on the rating label and compatible with the plug fitted.

If an extension lead is required, use an approved and compatible lead rated for this

appliance. Follow all the instruction supplied with the extension lead.

†Double insulated

is applied to the basic insulation to protect against electric shock in the event of failure of

the basic insulation.

Apart from replacing the fuse in the plug, no other electrical work is recommended on this

biscuit jointer.

: This product requires no earth connection as supplementary insulation