Bosch WAK24268IN Buku Petunjuk dan Petunjuk Instalasi - Halaman 27

Jelajahi secara online atau unduh pdf Buku Petunjuk dan Petunjuk Instalasi untuk Mesin cuci Bosch WAK24268IN. Bosch WAK24268IN 40 halaman.
Juga untuk Bosch WAK24268IN: Buku Petunjuk dan Petunjuk Instalasi (40 halaman)

Bosch WAK24268IN Buku Petunjuk dan Petunjuk Instalasi

Information on the display panel

Display
YES
NO
¼ flashes
E:17
E:18
E:23
D
N flashes
:
.
Other displays
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature falls.
Water level too high. Not possible to add laundry. If necessary, close the wash-
ing machine door immediately. To continue the programme, press Start/
Reload A .
Laundry may be caught. Please open and close the washing machine door
again and press Start/Reload A .
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Turn the water tap on fully,
The supply hose is kinked/trapped,
The water pressure is too low.
– Clean the filter in the water supply. ~ Page 25
– If an additional water filter has been installed (depending on model)
~ Page 34, check for contaminants and clean if required ~ separate
installation and cleaning instruction for water filter.
The detergent solution pump is blocked. Clean the detergent solution pump.
~ Page 24
The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.
~ Page 25
Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales
service. ~ Page 30
The childproof lock is activated; to deactivate: ~ Page 20
Too much foam detected, a rinse cycle has been switched on.
The mains voltage is too low. ~ Page 22
Undervoltage in the wash programme. The programme is extended. ~ Page 30
Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service. ~ Page 30
Faults and what to do about them.
en
27