Draper 03289 Petunjuk Manual - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Bor Draper 03289. Draper 03289 16 halaman. 18v cordless rotary drill

- BATTERY CHARGER (Fig.2):

This product is supplied with an automatic battery

charger designed and intended for recharging 18V

Ni-Cd and Li-Ion batteries only.

Li-Ion batteriey pack: Rating 3.2ah Max.

Ni-Cd batteriey pack: Rating 2.0ah Max.

DEFINITION:

Automatic Battery Charger:

Once connected to the mains supply recharging of

the battery can be left generally unsupervised

requiring minimal attention. Complex circuit

construction monitors the battery condition adjusting

the recharge current to suit. When the recharge cycle

is complete and to maintain the full capacity a low

output current will continue as required.

- BATTERY CHARGING:

To charge the battery pack, it must first be removed

from the drill. To release the battery pack, press button

on the front of the battery pack and gently pull the

battery pack from the housing. Plug the charger into a

230V/AC. 13amp, three pin socket. Place the battery

into the charger, making sure the + and - on the

battery line up with the + and - on the charger (+ to

+, - to -). The red and green LED will flash about 2

seconds to evaluate the condition of the battery pack,

then the red LED will extinguish and the green LED

still flash, this is part of the normal charging operation.

When the battery is fully charged, the green LED will

be on. The battery pack can then be removed and

used to power the tool.

- INSTALLING AND REMOVING BITS (Fig.3):

The drill is fitted with a keyless chuck, this means that

a chuck key is not required to secure the drill or

screwdriver bit. Place the drill bit shoulder into the

chuck as far as it will go, then hand tighten.

Short screwdriver bits need only be inserted to the

depth of the hexagon shank before tightening chuck

by hand.

OPERATION AND USE

FIG.2

†

FIG.3

- 7 -