Draper 56382 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Bor Draper 56382. Draper 56382 20 halaman. Sds + rotary

BASIC HAMMER DRILL OPERATIONS

9.6 TRIGGER SWITCH – FIG.7

Select the required function.

– Pull trigger

to activate the machine.

9.7 SDS+ SYSTEM – FIG. 8

The tool holder

chisels without the need for a chuck key.

– Insert the bit. It may be necessary to rotate the

bit to ensure it engages correctly.

DO NOT pull collar back to insert bit as the drill

bit will not seat.

– Check by pulling the bit to see if it's firmly seated.

Important: Always clean and lightly grease the tool

shaft before inserting into the chuck.

Take care that the dust protection cap is not

damaged. Allowing dust and debris inside the

holder will cause problems in the future.

– To remove a bit, pull collar

remove bit.

Warning! Bit will be hot after use.

A correctly fitted dusk mask, suitable for the activity

and in accordance to the relevant standard, must be

worn.

Swarf produced by metal drilling is extremely sharp.

Take precautions when clearing swarf. The burr left

on the hole is also sharp and should be removed

with a suitable tool.

9.9 DRILLING WOOD, PLASTIC OR

METAL

Although technically possible, Draper Tools do not

recommend the use of this machine for drilling into

wood, metal or plastic. This machine is designed for

drilling through brick, concrete and is engineered to

do so. This makes it an unwieldy machine to drill

wood, metal or plastic and there are tools that are

far more capable of doing the job with a greater

degree of control.

clamps SDS+ drill bits and

back and

FIG.7

FIG.8

- 13 -