Draper 56405 Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Bor Draper 56405. Draper 56405 20 halaman. 230v 5.2kg sds+ rotary hammer drill

BASIC HAMMER DRILL OPERATIONS

9.7 SDS+ SYSTEM – FIGS.13 – 14

The tool holder (1.2) clamps SDS+ drill bits and

chisels without the need for a chuck key.

– Pull collar (1.3) back.

– Insert the bit. It may be necessary to rotate the

bit to ensure it engages correctly.

– Release the collar to lock the bit in place. Check

by pulling the bit to see if it's firmly seated.

Important: Always clean and lightly grease the tool

shaft before inserting into the chuck.

Take care that the dust protection cap is not

damaged. Allowing dust and debris inside the

holder will cause problems in the future.

– To remove a bit, slide the collar (1.3) to the rear

and pull out the tool.

Warning! Bit will be hot after use.

A correctly fitted dusk mask, suitable for the activity

and in accordance to the relevant standard, must be

worn.

For work activities involving exposure to fine wood

dust, a mask rated to at least FFP2 should be used.

Swarf produced by metal drilling is extremely sharp.

Take precautions when clearing swarf. The burr left

on the hole is also sharp and should be removed

with a suitable tool.

Although technically possible, Draper Tools do not recommend the use of this machine for drilling

into wood, metal or plastic. This machine is designed for drilling through brick, concrete and is

engineered to do so. This makes it an unwieldy machine to drill wood, metal or plastic and there

are tools that are far more capable of doing the job with a greater degree of control.

(1.2)

FIG.13

FIG.14

- 15 -

(1.3)

(1.2)

(3)

(1.3)