Draper CHD96V Petunjuk Manual - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Bor Draper CHD96V. Draper CHD96V 13 halaman.

Halaman Cetak

BATTERY CHARGING

To charge the battery pack it must first be removed

from the drill. To release the battery pack squeeze

the grips located on either side of the battery

casing and gently pull the battery pack from the

housing (fig.1). Plug the battery charger unit into a

230V/A.C. 13 amp, three-pin socket. For the

CHD96V, CRD12V, CHD12V, CHD12V2, CHD14V &

CHD14V2 place the battery in the charger as

shown in (fig 2A). For the CHD142V Plus and the

CHD182V Plus place the battery in the charger as

shown in (fig 2B). Do not force. Ensure the battery

is inserted correctly. The indicator light on the

charger will now glow to show that the battery is

charging (fig.3). When the battery is fully charged

the light will go out (approx. 1 hour). The battery

pack can then be removed and used to power the

tool. To refit the battery pack to the drill push firmly

until the battery pack locates and snaps into place.

NOTE:

The battery was discharged after manufacturing

and will therefore require five to ten

charges/discharges before it reaches its full

capacity.

INSTALLING AND REMOVING BITS

This drill is fitted with a keyless chuck, this means

that a chuck key is not required to secure the drill

or screwdriver bit. Place the drill into the chuck as

far as it will go, then hand tighten.

Short screwdriver bits need only be inserted to the

depth of the hexagon shank before tightening the

chuck by hand. Alternatively grip part ✪✌ of the

chuck, (fig.4) and slowly run the drill clockwise

until the chuck grips the bit, then hand tighten.

DIRECTION SWITCH

This switch determines the direction of rotation of

the chuck, i.e. clockwise or anticlockwise.

To alter the direction of rotation, stop the drill and

push ✮✌, (fig.5), switch to the left or right. When

the direction switch is in the 'F' (forward) position

the chuck will rotate clockwise when viewed from

the handle end of the drill. When the switch is in

the 'R' (reverse) position the chuck will rotate

anticlockwise when viewed from the handle. Before

operation check that the switch is set in the required

position. Do not change the direction of rotation

until the chuck comes to a complete stop.

When the drill is not in use move the direction

switch to the neutral position (the middle setting).

OPERATION

Fig.1.

Fig.2A.

Fig.2B.

Fig.3.

Fig.4.

Fig.5.

- 8 -

✪✌

✮✌