Draper HD750VC Petunjuk Manual - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Bor Draper HD750VC. Draper HD750VC 12 halaman. Hammer drills

Halaman Cetak

Regular inspection and cleaning reduces the

necessity for maintenance operations and will

keep your tool in good working condition. The

tool bearings and gears are life-long lubricated,

however it is advised to check the condition of the

grease in the head every 100 hours, if necessary

replace the grease. The motor must be correctly

ventilated during tool operation. For this reason

avoid blocking the air inlets with hands. After use

disconnect the tool from the power supply and

clean carefully, use compressed air through

ventilation slots.

DISPOSAL

At the end of the machine's working life, or when

it can no longer be repaired, ensure that it is

disposed of according to the standard regulations

of the country in which it is being used, and that

the disposal operation is carried out by

specialized personnel following authorized

guidelines.

In all circumstances:

- Do not abandon in the environment;

- Do not dispose of together with solid urban

waste products;

- Contact the special recycling centres.

MAINTENANCE &

PART REPLACEMENT

WARNING

Disconnect the plug from the power supply socket

before replacing any parts.

BRUSHES

The brushes must be replaced after approx. 150-

200 working hours, or if they are less then 5-6mm

in length.

WARNING

For correct tool operation always change the

brushes in pairs, not separately. The use of original

Draper spare parts is recommended. After having

fitted new brushes allow the motor to run for at

least five minutes without load for the brushes to

bed.

IMPORTANT:

This operation should only be performed by an

authorized person.

REPLACING THE POWER SUPPLY CABLE

Check that the power supply cable is in good

condition, if not have it replaced by an authorized

person.The machine is fitted with a safety

clutch.

- 8 -