Draper 36761 Petunjuk Manual - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Melihat Draper 36761. Draper 36761 20 halaman. 360mm bandsaw
Halaman Cetak
- 1. General Information
- 2. Table of Contents
- 3. Contents/Declaration
- 4. Specification/Guarantee
- 5. Power Supply
- 6. General Safety Instructions
- 7. Additional Safety Rules
- 8. Unpacking and Checking Contents
- 9. Getting to Know Your Bandsaw
- 10. Assembly
- 11. Operation and Use
- 12. Operation and Use
- 13. Tips on Using Your Bandsaw
- 14. Tips on Using Your Bandsaw
- 15. Maintenance/Optional Accessories
ON/OFF SWITCH
When key is in the off/locked position, it
will prevent unauthorized operation of
the bandsaw (Fig.6).
The bandsaw is fitted with a no volt
switch. In the event of a power supply
failure the bandsaw will have to be
manually re-started (Fig.7).
CHANGING SPEEDS
1. Turn the main power switch off and
disconnect from the power supply.
2. Remove the front cover.
3. Refer to Fig.8. and check which pulley
steps to use for the desired speed
and adjust as required.
4. Change the belt on the motor pulley
or drive wheel will allow you to move
it from a larger diameter step to a
smaller step.
5. Replace the front cover.
OPERATION & USE
Fig.6.
Fig.7.
Fig.8.
DRIVE WHEEL
- 9 -
MOTOR PULLEY