Draper 02520 Manual - Halaman 12

Jelajahi secara online atau unduh pdf Manual untuk Penggiling Draper 02520. Draper 02520 20 halaman. 230v router
Juga untuk Draper 02520: Manual (20 halaman)

Halaman Cetak

PREPARING THE ROUTER

Note: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

8.1

PARALLEL GUIDE FENCE – FIG. 1

− If not already assembled, loosen the 2 fence

locking screws (17.1) on the parallel guide body

and slide the 2 guide rods (17.2) though the

mounting holes.

− Tighten the fence locking screws to hold the

rods in place to the parallel guide fence.

− Loosen the 2 parallel guide locking screws (9)

located on the base of the machine.

− Feed the parallel guide fence and rods through

the locating holes and channels on the base of

the machine (9.1).

− Adjust the cutting distance according to the job

in hand and then tighten the parallel guide

locking screws (9) to secure.

8.2

DUST EXTRACTION PORT

ADAPTOR – FIG. 2

Note: The majority of operations will require the

dust extraction port to be fitted. However, some

operations will be impossible with the port fitted.

These require appropriate safety equipment to be

worn.

If not already fitted in place:

− Locate the dust extraction port adaptor (7) into position on the machine base.

− Thread the two supplied fixings up through the base and into the nuts set into the port.

Note: Be careful to secure the port without damaging the plastic parts by over tightening the

machine screws.

8.3

DUST EXTRACTION

Inhalation of dust particles can be detrimental to health. The dust outlet (7) must be connected

with a dust extraction machine.

Note: Due to the outlet diameter, a size adaptation may be necessary.

Warning! All wood dust (including dust from composites like chipboards and fibre boards etc) is

hazardous to health; it can affect the nose, the respiratory system and the skin. For example MDF

(medium density fibreboard) which contains formaldehyde is a known carcinogen. In addition to

the above measures a correctly fitted dust mask, suitable for the activity and in accordance to the

relevant standard, must be worn. For work activities involving exposure to fine wood dust a mask

rated to at least FFP2 should be used.

(9.1)

FIG.

(7)

FIG.

– 12 –

(17.2)

(9)

(17)

(17.1)