Draper 29620 Petunjuk Manual - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Penggiling Draper 29620. Draper 29620 16 halaman. Bench grinders
Juga untuk Draper 29620: Petunjuk Manual (16 halaman)

Halaman Cetak

To correctly assemble, fit and adjust the tool

rests, spark deflectors and eye shields.

Carefully follow these instructions:

TOOL RESTS.

Attach the left and right hand tool rests ✳✌

using the four bolts ✴✌ and large washers ✵✌

as shown in Fig.6. Now adjust the tool rests so

there is approximately a 1.5mm (

between the surface of the grinding wheels

and the tool rests.

SPARK DEFLECTORS

Attach the two spark deflectors ✶✌ using the

two bolts ✷✌ and medium size washers ✹✌ as

shown in Fig.7. Now adjust the spark deflectors

so there is approximately a 1.5mm (

between the surface of the grinding wheels

and spark deflectors.

EYE SHIELDS

Place the eye shield frame ✺✌

over the eye shield ✻✌ fasten the

two parts together using the long

screws ✼✌, washers ✽✌ and nuts

✾✌. See Fig. 8.

Note: Do not overtighten as the

eye shield may crack.

Assemble the other eyeshield in

the same way.

Insert the shortest end of the

mounting rod ✿✌ a Fig.9 into the

hole ❀✌ in the shield frame ✺✌.

Now tighten the nut ❁✌ and round

headed bolt which are located in

the centre of each of the eye shield

mounting frames ✺✌. Fig.10 shows

the assembled eye shield

assembly.

ASSEMBLY (GHD150 & GHD200)

⁄

") gap

⁄

") gap

Fig.8.

Fig.9.

Fig.7.

✺✌

✿✌

❀✌

- 8 -

✴✌

✷✌

✻✌

Fig.10.

❁✌

Fig.6.

✳✌

✵✌

✶✌

✹✌

✺✌