Draper 65025 Petunjuk Manual - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Penggiling Draper 65025. Draper 65025 12 halaman. Variable speed die grinder

Halaman Cetak

NOTE:

The switch on this tool is fitted with a locking

device, allowing the tool to be operated for

long periods of time without interruptions.

Before inserting the plug into the socket, check

that the switch is in the unlocked position.

When the tool is not to be used for long periods

remember to leave the switch device in the

unlocked position.

GRINDING

The grinding point must be perfectly balanced.

After use the grinding point can be dressed with a

grinding wheel dresser, or with a similar tool, that

is readily available on the market. The grinding

wheel dresser can provide the most suitable forms

for the work that is to be performed.

WARNING

Excessive pressure on the machine does not

necessarily result in higher working speed, on

the contrary, it increases the wear on the

grinding point and can damage the die grinder.

REPLACEMENT OF THE GRINDING POINT

(Fig.3)

In order to fit the grinding point, use the wrenches

✫✌ provided with the machine.

1. Secure the collet shaft ✰✌ with one of the

wrenches ✫✌.

2. Using the second wrench ✮✌ loosen the collet

nut ✭✌ sufficiently to permit manual insertion

of the grinding point.

3. Insert the grinding point ✬✌ and firmly tighten

the collet nut ✭✌ with the second wrench.

IMPROPER USE

The functions and use of this tool are those

exclusively indicated in this manual.

VARIABLE SPEED SWITCH (Fig.4)

The die grinder is fitted with a variable speed

switch to enable you to vary the running speed for

different grinding points and applications. The

dial is numbered 1 - 6, 1 is the slowest and 6 is the

fastest.

NOTE: make sure the grinding tip is suitable

for use at the desired speed.

OPERATION & USE

Fig.3

✬✌

Fig.4

- 6 -

✮✌

✰✌

✫✌

✭✌