Draper Stormforce 65130 Manual - Halaman 14

Jelajahi secara online atau unduh pdf Manual untuk Penggiling Draper Stormforce 65130. Draper Stormforce 65130 20 halaman. Air die grinder

10. OPERATION AND USE

Note: Disconnect from the air supply before

carrying out adjustment, servicing or maintenance.

10.1 INSERT TOOL – FIG. 3

Warning: Select the grinding point appropriate for

the application, speed rated to the die grinder and

with the correct shaft diameter for the collet.

Inspect the grinding point before use. Do not use

chipped, cracked or otherwise defective products.

With the output shaft (2) held, loosen the collet

nut (1) with the other spanner. Insert the grinding

point shaft observing the minimum gripping length

of 10mm.

Secure the grinding point by tightening the collet

nut fully.

Note: Never tighten the collet nut without an insert

tool in the collet as damage will occur. Before

storage remove insert tool to prevent distortion of

the collet.

Note: Always wear safety goggles.

Warning: Never attempt to install cutting off

wheels or router bits.

10.2 TRIGGER – FIG. 4

Due to the risk of unintentional starting the die

grinder requires two separate and dissimilar

actions to power the tool.

Pivot the trigger release lever (8) forward. This

allows the trigger (7) to be pulled in toward the

body of the grinder.

10.3 AIR FLOW (SPEED) SELECTOR –

FIG. 5

Rotate selector (4) to regulate the speed most

appropriate for the application.

Rotate clockwise to increase, anti-clockwise to

decrease the air flow/speed.

FIG.

(8)

FIG.

– 14 –

(2)

(1)

(7)

(4)